Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Dimensions of the driving system of tool shanks Ingestion-build-103253 2 but the test described

2 but the test described in this Section is more appropriate to hydraulic hoses

— proven in use argument

Compliance with the best industry terminologies provided in BS 3130-2

Measured values and ranges for typical commercial print output for a number of regions are provided in Annex C

Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Dimensions of the driving system of tool shanks Ingestion-build-103253 2 but the test described1 Scope This part of ISO 5414 lays down the dimensions of tool chucks (end mill holders) with clamp screws designed for driving flatted cylindrical shanks in accordance with ISO 3338 2 and specifies the clamp screws used. It also gives the maximum diameter of the chuck nose. This part of ISO 5414 defines two types of drive: chucks with bores of d1 20 mm intended for driving cylindrical shank tools with a single flat, these tools being provided with